A door that's jumped its track can jam mid-cycle or hang at a dangerous angle. We realign or replace the damaged track section and check what knocked it loose in the first place.
We check whether a bent track, worn rollers, or a loose bracket caused the derailment, not just push the door back on.
We don't eyeball alignment. Plumb and level get checked and confirmed before the job is done.
We stock standard track sections for fast replacement rather than a temporary bend-back fix.
Vehicle impacts often bend both the track and the bracket mounting it to the frame. We check both.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
Track sections are checked for plumb and level, then adjusted and secured to the frame at the correct tolerance.
A replaced section restores the correct roller path immediately, without the recurring wear a straightened section can develop.
A roller jumping the track repeatedly usually means the rollers themselves need replacing along with the fix.
Collision damage often affects more than the visible dent. We check the full track and frame mounting system.
A track can only stay aligned if the brackets holding it are solid. We check and correct this on every off-track call.
Describing the symptom helps us bring the right track sections and hardware on the first trip.
Most off-track calls don't require a parts run thanks to a well-stocked van.
A full inspection prevents a quick patch that fails again within weeks.
Track realigned or replaced, verified plumb, and tested through a full cycle before we leave.
“Roller kept jumping the track every few days until they found the real cause, a bent bracket.”
“Track was off plumb by more than it looked. Fixed properly instead of a quick patch.”
“Storm debris jammed the track and bent it. Same-day repair got the door working again before dinner.”
Usually a worn roller, a bent track section, a loose bracket, or an impact from a vehicle or debris.
The door may be under spring tension even while off track, which makes manual handling risky.
We'll assess the severity and recommend replacement when straightening won't hold up long-term.
Pricing varies with the extent of the damage, quoted upfront before any repair begins.
No, we recommend not operating the door until it's repaired, since further damage or injury risk increases with continued use.
A straightforward realignment often takes under an hour; a full section replacement may take a bit longer.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591Our Craig coverage spans the full city and the zips around it, so a same-day window is realistic almost anywhere nearby.
Embedded Map Placeholder for Craig, AK